Networking Products

What Is a Crimping Tool? Types, Uses and How to Choose

A crimping tool is a hand or powered tool that joins a connector, plug or terminal to a wire by squeezing (crimping) it onto the conductor. A correct crimp makes a gas-tight mechanical and electrical joint without solder, which is why crimping is the standard way to terminate data, coaxial and power cables on site.

Types of crimping tool

  • Modular (RJ45 / RJ11) crimpers: fit 8P8C and 6P plugs onto network and telephone cable. Used when making Ethernet patch leads from network cable.
  • Coaxial crimpers: fit F-type, BNC and RCA connectors onto coaxial cable for TV, satellite and CCTV.
  • Ratchet terminal and ferrule crimpers: for insulated terminals, bootlace ferrules and small control wiring. The ratchet does not release until the crimp is complete.
  • Cable lug and hydraulic crimpers: for copper and aluminium lugs on power cables. Hydraulic crimping tools apply the higher force needed for large conductor sizes.

How to choose a crimping tool

  • Match the tool or die to the exact connector or terminal type and size.
  • Check the conductor range the tool is rated for (AWG or mm²).
  • Use a ratchet tool where crimp quality must be consistent across many terminations.
  • For large lugs, use a hydraulic tool with the correct die set.

How to use a crimping tool for RJ45

Strip the outer jacket, arrange the pairs in the T568A or T568B order, trim the conductors straight, push them fully into the plug so the jacket sits inside the strain-relief, then crimp in one firm, complete stroke. Test the finished lead with a cable tester before use.

Crimping tool, wire stripper or punch-down tool?

A wire stripper removes insulation or the cable jacket before termination. A crimping tool fixes a plug or terminal onto the conductor. A punch-down (IDC) tool seats conductors into keystone jacks and patch panels, which are not crimped. Most installers carry all three, plus a cable tester to confirm the result.

Shop the TMT Global range in the UAE: crimping tools, wire and cable strippers, punch-down and termination tools and cable and network testers, or browse all tools and testers.

FAQ

Can one crimping tool do RJ45 and coaxial connectors? Some combination tools have several dies, but each connector type still needs its matching die.

Why does a crimped RJ45 plug fail testing? The usual causes are pairs in the wrong order, conductors not pushed fully to the end of the plug, or an incomplete crimp stroke.

For crimping tools, strippers and testers for your project in the UAE, contact TMT UAE.